Qt4-26 Fly Ash Brick Machine/brick Making Machine Production Line for Sale

qt4-26 fly ash brick machine for sale

main block making mahcine        

1. Host machine First. put the main machine on the precast concrete ground. after putting. make main machine level and alignment. the vibration platform’s four angles as the reference. requirement roughness≤1mm. finished that put the big hopper on the main machine.

2.Conveyor belt Install the 6m conveyor or 8m conveyor( no digging absolutely). the way of installation conveyor has two ways. One is required the center of conveyor on straight line with main machine center. the top part of conveyor stretch into the big hopper opening about one-third. Another installation of conveyor required the center of conveyor is vertical with main machine center. at the same time the center of conveyor on straight line with small hopper center.

3.Mixer Mixer usually use vertical JQ350 or JQ500. required the mixer’s discharge hole aims to conveyor. make sure the material from mixer out can alight on the conveyor. Bolting the motor of mixer on the frame of mixer. adjusted the parallelism of motor’s vee belt pulley can according to the parallelism of mixer’s vee belt pulley. check the tightness of motor’s vee belt pulley. use hand press the belt pulley 2cm. that is ok. Finished adjustment. fastening bolt.( Put 10kgs 35-40# machine lubrication into the reducer of JQ350. put 15kgs 35-40# machine lubrication into the reducer of JQ500 ).

4. Oil part Finished installation. check the reducer. shaft sleeve. vibration box and every part which need to lubricate. add the lubrication oil.

5. Setting date of electrical equipment. Finished installation of electric control cabinet. lead the power into the main machine distribution box. mixer and conveyor. put the knife switch neighbour side with the mixer. convenient to operation.(requirement the general power has leakage protection circuit broker ). General power uses wire specification: 3x16mm. Main machine uses wire specification: 3x6mm. Mixer uses wire specification: 3x4mm. Conveyor uses wire specification: 3×2.5mm.

 technical parameter 

cetification          

workshop       

 customers  

delivery&packge            

Packing is nude package or plastic according to customer need

1. The whole brick machine production line equipment is mainly the full container sea shipping.
2. Brick machine equipment finish manufacturing and testing. next to clean up. and then do another paint protection.
3. Before shipment to use plastic film winding. wrapped the entire brick machine in case of water or moisture.
4. Then load brick machines into the container by forklift.
5. During loading to tighten the machine with reinforcement ring in container. so as to avoid the damage by transport bumps on the brick machine.

our services  

1) Send the technicians to carry out the installation and debugging of equipment for the foreign users with compensation. Countries or regions with unstable political situation or in the throes of wartime are not included in our plan.
2) Train the users to command the equipment and guide them for safe production.
3) Explain the routine maintenance of equipment carefully and remove common faults.
4) We are responsible for all the repairs that caused by our quality problems within one year’s warranty. (We will provide one set of spare parts/wear & tear parts free of charge with shipment.)
5) For some countries whose visas are difficult obtained. customers can also send their technicians to our company to receive free guidance and training.
6) Accept suggestions for improvement put for